...
LDO is running
ADC values for VBAT monitoring are sane
Still need to plug in anemometer and wind vane.
Handing this build off to a local co-worker for extended feedback.
Added an OLED monitor port for basic diagnostics (not to be connected all the time due to current draw)
Moving on to my load/charge switch module on next unit
Rain gauge is functioning
Wind anemometer and vane operate
Summary of PCB bugs
R11 tied to GND, not 3V3, tie right side of R11 (ESP32 towards you) to 3V3 somehow.
Use jumper wire or solder to 3V3 in an unused I2C port connection point
C6 is not needed as C10 value controls the RC time constant on EN pin
C8 is redundant? C3 already covers output from LDO