Binding

23 Jul 2018 

• Binding process was painless

Required Hardware

23 Jul 2018 

Think ahead on hardware as this stuff is small and difficult to find. M3 misc hardware arrives on 23 Jul 2018 

3.5mm bullet connectors were also an afterthought. I made a connector holder by drilling a 1/8" hole in a block of wood to hold the connectors while soldering wires to them

Motor spin-up testing

23 Jul 2018 

• 1 ESC was EXTREMELY hot to the touch. Discuss with Cyril.
  • Just power to ESC, not motor connected

Prop Balancing

• James Hughes23 Jul 2018 Balance props

Initial Setup and Flight Test

• James Hughes Meet with Cyril to go through binding process