On this page

Contributors

No contributors found for: authors on selected page(s)

Wired Assignments

Typically restricted addresses 2-35, but skip 8

Cab Type	Lowest Address	Highest Address	Total Radio Cabs
ProCab	2	63	62
Non ProCab	2	63	62

Non ProCabs are Cab04's, Cab05's or the Cab06's.

Typically restricted addresses 2-17, but skip 8

Cab Type	Lowest Address	Highest Address	Total Radio Cabs
ProCab	2	17	16
Non ProCab	2	49	48

Non ProCabs are Cab04's, Cab05's or the Cab06's.

Power up your Powerhouse system.

just removed from the cab

NCE PROCAB V1.3

CAB ADDRESS = 02

In this case, you will press “3” (valid range = 2-63) followed by ENTER.

discussed later in this manual.

Cab04 has internal DIP switches that need to be set

To change the cab address:

1) Turn on the command station

2) Unplug your cab from the command station

3) Press and hold down the SELECT LOCO button on the cab while plugging in the

cab. The cab will now enter its internal setup program. This is indicated by a

flashing of the status LED.

4) Press “1” to enter the cab address setup mode. Notice the flashing of the LED

slows to indicate it is ready to accept the new address.

5) To change the address type in a new address such as 3 followed by the ENTER

key. Valid cab addresses are 1 to 63. If you enter a number outside this range

the LED will flash rapidly indicating an error. If you get an error go back to step

2. This finishes setting the cab address.

NOTE: previous versions of the cab required setting internal “DIP” switches to the

cab address. This switch is still included inside the cab but is non-operational for

setting the cab address. however switch numbers 7 and 8 should always be up (on)

unless the optional radio is installed.