| Table of Contents |
|---|
Placement of insulators
The FreeMo spec allows for insulators at the end of modules. We will need to have this at every module in order to facilitate signal blocks.
...
(excerpt from the spec)
Insulator can be an insulated rail joiner or “air insulator” cut in the rail. Either is acceptable.
1 to 1 Module
No insulators are needed within the module.
...
Configuration | Number of detectors |
|---|---|
1 to 1 | 1 |
1 to 1 with siding | 1 |
1 to 2 | 3 |
1 to 2 with siding | 3 |
These will be inserted on the red wire side of the module. If you do not have a block detector module yet, please add 3” of wire (red wire only) to your to be able to cut one into your circuit.