Skip to end of metadata
Go to start of metadata

You are viewing an old version of this page. View the current version.

Compare with Current View Page History

« Previous Version 35 Next »

Hardware Issues/ Enhancements

  • ISSUE Stronger power supply. 5V operation works, but 3.3V battery does not. Starting to see evidence that this may be an issue with my build. Need to keep open minded.

  • Upgrade from 200mA LDO to 500mA LDO solved my RESET issue.

    • Now using TC1262-3.3V LDO

  • ENHANCEMENT Hall Effect sensors on measurement devices
  • ENHANCEMENT I2C based counters for rainfall and wind anemometer revolution count
  • ENHANCEMENT Full low current analysis
    • Mount ESP32 on PCB and keep only what I need in the design

Troubleshooting the RESET issue I see on my PCB

  1. When RESET or initial power on happens on non 5V USB power (using LiIon battery and MCP1700)

    1. WiFi radio begin() will fail and system reboots

    2. second connect will pass

    3. sequence fails again after deep sleep and timer WAKE

  2. TODO: Scope 3.3V supply and look for any signs of droop

    1. monitor regulator output and 3V3 pin on dev module

  3. Observed that fully charged battery will RESET controller after deep sleep, but as voltage gets < ~4.1V controller stops resetting.

4:30am - Experiment start

19:10pm

  • MQTT topic added to report boot count

  • Boot count starts to increment after deep sleep, but microcontroller randomly still RESETs

  • I now have a way to know when things are working properly

  • One can clearly see when boot count is getting RESET to 0

Left graph: ADC reported battery voltage vs. time

Right graph: bootCount vs. time

**Notice how bootCount periodically resets after incrementing for some time. This is typical behavior is the ESP32 RESETs when activating WiFi radio.

I replaced the MCP1700 with a TC1262-3.3V LDO (500mA) and the system works on a fully charged battery immediately! I’ll post results from overnight run to see if any system resets occur.

Happy to report that I ran overnight without incident!

Long term TODO:

  • Hall Effect sensor based wind and rainfall measurement
  • I2C based wind counter, easier to periodically read instantaneous wind values with ULP
  • Layout ESP32 on main PCB, get rid of the dev module entirely
    • Really attack the deep sleep current support
    • Add FET switch for powering down all peripherals while in deep sleep
    • No power LED constantly drawing current
    • LoRaWAN stack
    •  

Log of efforts

Power supply reboot debug issue

Ordered 500mA LDO’s from Microchip. TC1262 (qty 10)

New LDO works great! Very haphazardly tacked on the existing PCB design, but no more brownout and RESET.

Battery Life Testing

Using a 3100mA LiIon cell

6am, battery testing with 15min timer settings to evaluate battery life with no recharge

  • No labels